>> homepage Post messages Homepage:Login:Register:Soul:Top Host 
Forum style Interface Style:  

vp-996 H27U2G8F2CTR Reply  
handsome
eliran
Hi
I have a problem with this chip H27U2G8F2C read all ok but when I verify
I get this error
>>.Verify......
>>Device Address:08400000H Device Data:55H Buffer Address:08400000H Buffer Data:00H
>>Verify fail!
>> 447.06Sec
Pls advice
Go back list [ Posted:2014-07-23 22:19:26 ] Edit Administer top

Re:AT45DB041D - SSU page 256 8SO ISP Reply  
handsome
myx1
do you use latest software? if not, just download it on our web.
http://www.weilei.com.cn/dow.asp. 4.6.4
chick "config",choose "used(page=2112)","hard copy(no verify)".and have a try.
Go back list [ Posted:2014-07-24 09:23:33 ] Edit Administer Top

Re:vp-996 H27U2G8F2CTR Reply  
handsome
eliran
Hi I am using the latest software and did as you requested but not helping.
>>.Verify......
>>Device Address:01458000H Device Data:00H Buffer Address:01458000H Buffer Data:FFH
>>Verify fail!
>> 68.27Sec
In additional every time I read the chip I get different checksum
Go back list [ Posted:2014-07-24 16:58:49 ] Edit Administer Top

Re:vp-996 H27U2G8F2CTR Reply  
handsome
myx1
read it and then check address from 01458000H to 1479000H.
if all "00",this means this block is a bad block,can not be wrote.read always 0x0.
as nand flash,each one may have less than 3% bad blocks of the factory
this H27U2G8F2C,has 2048 blocks, each block has 0x21000.
Go back list [ Posted:2014-07-25 09:28:24 ] Edit Administer Top

Re:vp-996 H27U2G8F2CTR Reply  
handsome
myx1
if your useful datas are before 0x1458000H,after program it can be run well on your board.
if over 0x1458000H,it may be ok or not.you have to use another one that has no bad blocks from 0 to the end of the useful datas.
0x1458000/0x21000=0x9D
[ The message is modified by myx1 ]
Go back list [ Posted:2014-07-25 09:29:03 ] Edit Administer Top
Total reply 4 ,total 1 page Forum Previous Next[1]

Reply the topic
Topic: *(Within 40 characters)
Author: *(The username should be within 10 characters)
Password: *(When posted the message for the first time,it will automatically registered)
Verify Code: * 8706
Sex: male female (There is no need to choose if you have registered)
Head portrait: (There is no need to choose if you have registered)
E-mail:
Q Q:
ICQ MSN
Homepage:
Emoticons:
Ubb label:

Message
body

            (Ctrl+Enter submit)
Web homepage | Contact us | About us

Tianjin Weilei Technology Ltd.

203.13 ms